Colour correction

Report
Emotions
0 Disown client
0 Pressure
0 Confusion
0 Where do you start
Break it down
0 Write it down
0 Plan
Who has colour correction
0 Regular clients who want a change
0 Sun bleached
0 ‘do it yourself clients’
0 Bands of colour
0 Light to dark
0 Change tone
0 Dark to blonde
0 Root glare
0 Over highlighted
How to get the information from
a client
0 Open Questions
0 What
0 Who
0 When
0 Why
0 Listen
0 Body Language
What do we need to consider
Under
promise and
over achievebe realistic
Cost
Texture/
porosity
Is it realistic
What you
need to
consider
Will it last
Can it be
achieved
Expectations
Ability of the
hairdresser
Time factor
Colour family's
0 Perfecton by colour fresh
0 Colour fresh
0 Colour touch
0 Special Mix
0 Sunlight's
0 Relights
0 Colour touch plus
0 Koleston perfect
0 Special blonde
0 Special mix
0 Magma
0 Blondor
Restoring depth and tone
Comb through
Minimum fade- replace tone
0 Root application
0 Dampen hair gently and massage the colour
0 Working from crown area take a section of the hair
and work the colour through the mid lengths and
ends with a comb
0 Continue this method through the rest of the hair
Medium/maximum colour fade
Colour touch
0 Section the hair from ear to ear
0 Apply colour from roots through to the mid lengths
and ends using a flask
0 Work the colour into the hair using the hands
0 Rinse off excess colour after development time
Koleston rinse
normal to porous hair, replace depth and tone
0 15-30ml tint
0 15ml 9%welloxon perfect
0 60ml warm water
0 Mix and apply on completion of regrowth application
0 Develop as normal
Anti fade colour bath
replace depth and tone on very porous hair
Stage one
0 15ml of tint
0 45ml warm water
0 Mix and apply on completion of re growth application
0 Develop as normal
Stage two
0 Mix 10ml 9% welloxon
0 40ml warm water
0 Apply to lenghts and ends
0 Develop for a further 5 minutes
Cleansing rinse
0 The hair is pre shampooed to open the cuticle
0 Blondor multi blonde powder and warm water are
mixed together to a pouring consistency
0 Apply this to the hair with a sponge or a brush
0 The hair lightens over the development time
0 Shampoo and post treatment
0 The hair is now ready to be recovered
0 Good for removing unwanted tone
Cleansing shampoo
The hair is pre shampooed to open the cuticle
Mix 30 grams of blondor powder
30mls 6% welloxon
60mls warm water
15mls shampoo
This is applied to the hair with a brush or sponge to
required areas
0 The hair lightens over the development time- visual up to
20 mins
0 Shampoo and apply post treatment
0 The hair can now be recoloured
0
0
0
0
0
0
Mild Lightener
0 Mix 1 part of blondor multi powder and 3 parts
welloxon perfect pastel developer
0 This is applied to the hair with a brush to the required
areas
0 The hair lightens over the development time before
being shampooed away, 50 mins without heat or 25
mins with heat- but stay and visual check
0 Shampoo and post treatment
0 Hair can then be recolored
Removing bands
0 Mix 10/0 KP in normal way
0 Apply to dark areas
0 Develop up to 60 mins without heat (30 mins with)
0 When sufficient lift has been achieved (warm in tone),
comb off excess with large tooth comb, leaving
approximately 20% tint on the hair
0 Now colour to your target colour
Pre Pigmentation
Perfecton (under
colour fresh)
10
/3
Colour touch (under
colour touch)
Koleston
(under Koleston)
/34
0/33
9
8
7
/43
0/43
6
5
/45
4
/44
0/45
3
2
Neat to diluted 40mls
5-15 mins
5-10mls- 60mls 1.9%
5-30cm to 60mls
warm water
Natural- Minimum
vibrant red- Max
Rich natural- min-med
Deep brown- med-max
Problems and causes
Problem
Colour to dark
Patchy dark
Too red
Patchy light
Colour to light
Colour to ash (green)
Not light enough
White hair not covered
Not red enough
Root glare
Colour banding
Bleach too warm(orange)
Cause
Remedy
Problem
Cause
Remedy
Colour to dark
Wrong colour choice
Left on to long
Too low peroxide
Cleansing shampoo
Patchy dark
Porous hair
Incorrect application
Mild lightener
10/0
Too red
Depth to light
To high peroxide
To much tone
Post pigment treatment
Cleansing rinse
Patchy light
Application uneven
Re apply and tone
Colour to light
Left on to long
Incorrect application (over lapped)
Pre pig and tone
Colour to ash (green)
Wrong tone used
Not pre pigmented when going from light
to dark
Post pigment with red
Cleansing rinse
Not light enough
Wrong peroxide
Not left on long enough
Reapply
10/0
White hair not covered
Not applied correctly
Wrong base
Re apply
Not red enough
Wrong depth
Wrong tone
Colour applied on to darker depth
Post treatment
Root glare
Coverage over grey
Incorrect application
Reapply
Cleanse ends
Colour banding
Overlapped
Wrong colour used on previous root
application
10/0
Mild lighter
Bleach too warm(orange)
Not left on long enough
Re lightener
Add blue to it
Case studies
Target colour 6/43
7/0
10/0
Target colour 6/7
6/
0
6/7
4/0
Target shade 6/43
7/0
10/0
Pre pig ends with Koleston 0/43 (30cm)
After 15 mins blot dry
Then apply 6/43 20 vol roots to ends
Or colour touch mid lenghts and ends
Or anti fade colour bath
Target Shade 6/7
6/
0
6/7
4/0
Mild lightener on the 4/0
Then apply 6/7 20 vol KP or C.T 1.9% on roots
On ends apply 6/71 C.T and 0/88 SM to kill undertones

similar documents