UPCSC

Report

This tool needs to be installed on your terminal before you start the
registration process.

The tool can be downloaded from the web or can be installed through a
CD.

This section explains the process of installation using a web interface.

The precise steps and screen-shots for installation are provided hereafter
NOTE: While using data card, the LAN card should be enable for the
MAC address.
Using the Internet you need to access the CSC online monitoring website and
authenticate yourself, for authentication your SCA will provide your CSC ID
and password. .
Once CSC user logs in using his/her CSC-ID and password the CSC Registration Status
gets displayed as shown below:
Various Status messages that can appear on the screen are indicated in the table
below:
STATUS
REASON
Commissioned
A CSC has been commissioned with an CSC-ID and
password but has not installed the tool on any IT
terminals.
Registered (Partial)
A CSC has been commissioned with an CSC-ID and
password and has installed the tool on some or few of
its IT terminals.
Re-Register
A CSC has been Registered, but it needs to Re-register
installer on its IT terminal.
Once you are successfully logged in, your Registration status will appear on the
screen, the system will prompt you to download the installer in either of the
Operating Systems (Windows/Linux).
Proceed for Installation hereafter depending on your choice of Operating
System.
For Install Process Windows click here III: Installation for Windows OS

This tool needs to be installed on your terminal before you start the
registration process.

The tool can be downloaded from the Web or can be installed through a
CD.

This section explains the process of installation using an installer CD.
Using the CD is preferable if the bandwidth speed is low.

The precise process for installation is provided hereafter

For Windows click here
This tool needs to be installed on your terminal before you start the registration process. The
tool can be downloaded from the Web or can be installed through a CD. This section explains
the process of installation using Windows OS. The precise steps and screen-shots for
installation are provided hereafter.
Once the client has been successfully saved on your computer or once the CD has been
inserted on your machine, a self installer pop-up would prompt you to click 'Next' to complete
the installation process. Further keep clicking 'Next'/'OK'/ 'Install'/'Yes' whenever prompted.
After successful installation process the system will automatically take you
to a registration process! Click here to proceed to Registration
To complete registration execute the following steps.
1. Fill in your CSC ID and Password
On the CSC Registration screen provide your valid CSC Login-ID and Password to register
Wait until registration process is
under progress.
Once you have registration your
system will restart.
Once the system restarts login to the online monitoring tool. The Registration
Status would now show 'Registered'.

Re-Installation process is meant to down load the installer once again on the
machine on which you have successfully installed the Tool. These exceptional
events are:

CSC terminal is reformatted

CSC terminal suffers from a virus attack

CSC hard drive is reformatted

Any critical component is replaced causing change of MAC address of a terminal

A newer version of this tool is published
Once a CSC is set to Re-Registration mode the system is ready for Re-Installation

similar documents