Super Flyer 8, 10 & 12 Trampoline Packages

Report
www.supertramp.co.uk
Instructions
1





SITING YOUR TRAMPOLINE
Your trampoline works best and is safest if it is dead level. If your trampoline is fitted
with a safety enclosure then potential hazards within 2 metres of the trampoline like
paving stones, fences, pools, tree trunks and buildings will not be critical. Without a
safety enclosure it is vital to keep clear 2 metres of lawn space all round the
trampoline.
Always ensure that the area above the trampoline is clear of overhead cable and
branches. Even if the cables and branches are way up high, birds will roost on them
and use your trampoline for target practice.
Garden trampolines are designed to stand on a lawn. If they are on concrete or gravel
the underside of the leg bases will wear away quite quickly. If you are planning to site
your Trampoline on concrete or on a patio you should fix floor guards to your
Trampoline legs.
If you need to level your trampoline try and raise one side by the same distance that
you sink the other. That way you still have sufficient clearance beneath the trampoline
to prevent larger and more energetic bouncers bottoming out and hitting the ground.
Unless the slope is very slight just blocking up the lower legs will not work well as the
trampoline will tend to move down the slope and fall off the blocks. It is better to
create a groove for the uphill legs to rest in or alternatively ground anchor them so
they cannot creep down hill. A quick and simple way to check that your trampoline is
level is to take off a spring and see if it will roll downhill on the trampoline bed.
2
Part
8ft
10ft
12ft
14ft
6
6
8
8
3
3
4
4
6
6
8
8
48
X 5.5 inch
54
X 5.5 inch
72
X 7 inch
80
X 7 inch
1
1
1
1
1
1
1
1
Top Rails
Leg Bases
Leg Extension
Springs
Jumping Bed
Frame Pads
3
a)
b)
c)
d)
Lay frame parts out on a reasonably level part of
lawn.
Assemble trampoline LEGS by sliding onto LEG
BASE
Once you have joined the leg extensions to the leg
bases start linking them together by fitting the top
rail
Work around the trampoline to complete your
frame
4
a)
b)
c)
d)
e)
f)
Unfold the black poly-mesh bed on the ground inside the completed
trampoline frame
Before fitting any springs, note that the extended hook on each spring fits into
the frame and the smaller hook fits into the triangular anchor on the bed.
Fit one spring into the slot just to the right hand side of a top rail joiner then
attach the spring to the bed on the inside of the frame
Then work your way round the frame and attach a spring immediately to the
right of each top rail joiner and to the appropriate triangle on the bed
Fill in the gaps by attaching springs midway between each of those already
fitted.
Repeat until all of the springs are attached.
5
a)
b)
Place the frame pads on the trampoline and line up the enclosure pole holes
with the T section top rail joiners
Then attach the elasticated straps one to the frame and one to a spring and
then cover with the side skirt
6
Products
8ft
10ft
12ft
14ft
Enclosure Net
1
1
1
1
Bottom poles
with foam
6
6
8
8
Top poles
with foam
6
6
8
8
Enclosure
pack of laces
1
1
1
1
Nuts and
Bolts +
Spanner Pack
1
1
1
1
7
a)
b)
c)
Place the bottom enclosure poles though the pad hole and into the slot
underneath in the T joiner
Complete the assembly by using the nut and bolt provided
Then clip on the top poles together and then secure using the screws
provided.
8
a)
a)
Attach the net using the adjustable loop to the top pole top cap
Do this all the way around the trampoline
Laces are used to attach the bottom of the enclosure net to the triangular
anchors on the trampoline bed. To do this tie one end of a lace to an anchor
and then 'stitch' by going through the nearest hole at the bottom of the
enclosure net, and back down to the next triangular anchor and repeat all
around the enclosure and the trampoline bed, adding additional laces as
required
Complete trampoline
9


Please attach the caution notice provided in the instruction pack to the
trampoline with the cable ties provided
It is important that this notice is fixed where it can be seen by users before
they get on to the trampoline
Caution
Read the instructions before use
The trampoline should be sited on a clear and level grass surface
Only one user at one time
Misuse and abuse can cause serious injury
Inspect trampoline before use and replace any worn, defective or missing parts
Always jump in the middle of the trampoline
Do not attempt somersaults or advanced moves without qualified supervision
Always use trampoline with pad and enclosure on
Do not bounce off trampoline onto the ground or any other objects
10
If the trampoline is bigger than 8ft we provide a ladder so
that it is easier to enter and exit the trampoline
a)
b)
c)
Attach the ladder base using the ball catch
Attach each ladder step to the two uprights ensuring
they fit correctly (step facing you, bolt to the front
using the nut on the back
Fasten each step securely using the spanner provided
11
12
IMPORTANT Please keep
your proof of purchase it
will be needed to make
a claim
* Ladder – 1 year guarantee
13
Twitter :
Feel free to tweet us a picture of your trampoline
@supertrampuk
@JetSportsLtd
Facebook:
https://www.facebook.com/supertrampltd
Pinterest:
http://www.pinterest.com/jetsportsltd/pins/
14
For more information on trampolines check out Get Britain Bouncing and for
spare parts visit our website
www.supertramp.co.uk
www.getbritainbouncing.org.uk
15

similar documents