Zynq intr part 3

Report
Zynq intr – part 3
© Copyright 2014 Xilinx
.
Content
Description of the effects on interrupt mapping when migrating a
project from a Vivado 2013.x project to a Vivado 20143.x project.
Description of the special case for a single interrupt mapping
© Copyright 2014 Xilinx
.
Special cases
Migrating a project from 2013.4 to 2014.x
Let’s take a project used in 2013.4 and migrate it to 2014.3
© Copyright 2014 Xilinx
.
The upgrade process
The IP upgrade is automated by Vivado.
The Concat block gets updated to the latest version in 2014.x
The PS7 block gets updated to the latest version in 2014.x
© Copyright 2014 Xilinx
.
Upgrade from 2013.x to 2014.x
Concat block
The IP upgrade means a change of order for the interrupts
compared to the order in 2013.x
Concat in 2013.x
Concat in 2014.x
© Copyright 2014 Xilinx
.
Upgrade from 2013.x to 2014.x
IRQ_F2P_MODE parameter
Let’s look at the
parameter value for a
project that was
migrated from 2013.x
to 2014.x:
The parameter value is
now “REVERSE”.
© Copyright 2014 Xilinx
.
Upgrade from 2013.x to 2014.x
Generated PS7 source file internal interrupt
vector
As a result of the IRQ_F2P_MODE parameter value being
“REVERSE”, the internal irq_f2p_i vector is now representing the
mapping from 2013.x:
© Copyright 2014 Xilinx
.
Upgrade from 2013.x to 2014.x
© Copyright 2014 Xilinx
.
Conclusion for an upgrade
To keep the 2013.x original interrupt mapping it is necessary to
reverse the input interrupt order on the concat block.
The “REVERSE” parameter then takes care of arranging the
mapping as was previously implemented in 2013.x.
© Copyright 2014 Xilinx
.
Test Design
Let’s remove the concat block and use a single interrupt:
© Copyright 2014 Xilinx
.
2013.x
As there is no concat block involved it is a straight-forward
mapping. The PS7 code is as previously seen:
In0 is mapped to ID 91.
© Copyright 2014 Xilinx
.
2014.x
The IRQ_F2P_MODE parameter from the PS7 source file is set to
“DIRECT”.
In0 is therefore mapped to ID 61.
© Copyright 2014 Xilinx
.
In 2014.x
© Copyright 2014 Xilinx
.
Migrating the project form 2013.x to 2014.x
The PS7 parameter IRQ_F2P_MODE is now set to “REVERSE”:
© Copyright 2014 Xilinx
.
Upgrade from 2013.x to 2014.x
Generated PS7 source file internal interrupt
vector
As a result of the IRQ_F2P_MODE parameter value being
“REVERSE”, the internal irq_f2p_i vector is now representing the
mapping from 2013.x:
© Copyright 2014 Xilinx
.
Upgrade from 2013.x to 2014.x
In0 mapping did not change compared to the implementation in
2013.x because the IRQ_F2P_MODE parameter was set to
“REVERSE”.
© Copyright 2014 Xilinx
.
Follow Xilinx
facebook.com/XilinxInc
twitter.com/XilinxInc
© Copyright 2014 Xilinx
.
youtube.com/XilinxInc

similar documents